![]() pyparallel platform_system != “Windows”.Download the file, open your terminal, navigate to the directory you saved the file to, and run: conda env create -n psychopy -f psychopy-env.yml We provide an environment file that can be used to install PsychoPy and its dependencies. Installation instruction is similar to the below I actually deleted “psychopy” environment so that I can freshly start from scratch and check any replicable condition I can find. I was able to synch and log in to for the first time ever !!! ![]() e.g., sudo apt install overlay-scrollbar-gtk2 \ Then, when you install the modules using apt, psychopy will be able to find them. Where is the location of your anaconda installation. The only solution I know of would be to remove the libraries from conda, e.g. If not, great! Could you report whether that’s the case? If you do see those messages, I think this is another case of the libraries provided by conda-forge being incomplete. However, when you start psychopy, you may still see warnings about modules failing to load (e.g., Failed to load module "overlay-scrollbar"). I think that an environment you create with this file will allow you to sync your experiments online. pyparallel platform_system != "Windows" The main difference from the provided one is that it installs opencv from the default conda channel, and so won’t pull in glib name: psychopy This means that any system level install of libraries will be ignored in favor of the ones from conda-forge.Īs a workaround, you could use the following as your environment file (e.g., psychopy-env.yml). As I understand it, the basic issue with the failed sync is that there are old/incomplete libraries on conda-forge, and these older libraries get installed when creating an environment from the psychopy environment file. Yeah, installing in a conda environment on Ubuntu is currently pretty finicky (see #2836, #1979, and #2441). Unable to access Network Folders in GNOME “Unable to access location, TLS/SSL support not available” when trying to connect to webdav I saw this problem everywhere, not just psychopy When I google TLS/SSL support not available install glib-networking Now, I tried to install all version of webkitgtk ![]() I was able to go further, but I couldn’t do anything else at all. TLS/SSL support not available install glib-networking I always receive similar error messages, when I clicked online synching buttons that say I did everything as they mentioned, but I still can’t synch to However, there are still problems to synch Psychopy builder to Time: Debug: Adding duplicate image handler for ‘Windows bitmap file’ Gtk-Message: time: Failed to load module “canberra-gtk-module” Gtk-Message: time: Failed to load module “atk-bridge” ![]() Gtk-Message: time: Failed to load module “overlay-scrollbar” I can run a created experiment locally.Įven though I can still use Builder and Coder, there are still some wierd messages like below Now, I am able to use Psychopy Builder and Coder. Libwebkitgtk-1.0-0 is already the newest version (2.4.11-3ubuntu3).Īccording to below forum discussion, and I had same experienced, I uninstall Psychtoolbox. Note, selecting ‘libwebkitgtk-1.0-0’ for regex ‘libwebkitgtk-1.0’ Note, selecting ‘libwebkitgtk-1.0-common’ for regex ‘libwebkitgtk-1.0’ Now, when I type the above code again, it shows below feedback. I used the environment file, and I made sure to install webkitgtk by typing below. I installed psychopy following instructions of this link **PsychoPy version : 2020.1.2 conda installedīe able to synch a created project from Psychopy Builder to ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |